Manual Outs

Updated December 3, 2021

Components types affected:

Sheetfed

Digital

Web (Manual Override # Up option)

Business Forms (Manual Override # Across option)

Wide Format

 

By default the system will automatically calculate “outs” from the Finished Size to Press sheet and/or Press and Parent sheets. The user may opt to override system calculations by selecting the Manual option and entering the desired value.  Each Component type acts similar but in all cases when the Manual Outs option is selected the system will grey out the View Layout button for the component because the system cannot calculate how the display should be viewed.

 

Sheetfed Component

When the user selects Manual adjacent to Press Sheet Size or the Parent Size, the system will display the No Across/Around fields below the Gripper/Side G. fields. These fields are normally grayed out and display the automatically calculated values (if possible).

 

 

These fields are intended for information only. The values entered will have no effect on calculations, but they may be added to a custom job ticket. Only the value entered into the appropriate Outs field will be used.

 

Digital Component

This works identically to the sheedfed with the exception that the user will not have the option to enter the informational No Across/Around information.

 

Web Component

This feature is only available to define the manual Number of Signatures Up in relation to Signature Size to Roll Width x Cutoff. The option only takes affect when it is checked and uses the Number of Sigs Up value to calculate the paper and impressions required. If the option is not checked than the value in the Number of Sigs Up is ignored.

 

Business Forms 

 

Wide Format Component

When the user selects Manual adjacent to Press Sheet Size or the Parent Size, the system will display the No Across/Around fields below the Gripper/Side G. fields. These fields are normally greyed out and display the automatically calculated values (if possible).

 

 

These fields are intended for information only. The values entered will have no effect on calculations, but they may be added to a custom job ticket. Only the value entered into the appropriate Outs field will be used.