Use Finished Size instead of Press Size in Square and Linear Footage/Metre Calculations

Updated November 5, 2022

Applies to : Sheetfed, Digital Press Processes

This option causes the system to calculate square or linear foot cost using the component Untrim/Sig Flat (Sheetfed component) or Untrim Size (Wide Format component) rather than the Press Sheet size.

 

 

Typically set for Sheetfed or Digital presses this option will use the Untrim/Sig Flat (Sheetfed component) or Untrim Size (Wide Format component) as the basis for the Units per Hour calculation.